Homeowner advice

How to clean window screens and tracks between professional cleans.

To clean a window screen, brush or vacuum the dust off first, wash it gently with mild soapy water and a soft brush, rinse it, and let it dry before it goes back in. Tracks are the same idea: vacuum the loose dirt, loosen the rest with a damp cloth or small brush, then wipe them dry. It takes a little patience, not special tools. Here is how to do it without bending a screen or making mud in the track.

The short version

Dust before you add water, use mild soap and a soft brush, rinse well and let screens dry fully. Vacuum tracks before you wipe them. Skip the pressure washer, bleach and ammonia, and leave upper-floor screens to a crew. Screens, tracks and a frame wipe-down are included in every Beam’s residential window clean.

Why screens and tracks get so dirty here.

The Okanagan is dry, and dry country is dusty. Wind picks up dust from gardens, gravel and construction and pushes it against the house. Screens catch it like a filter, and tracks collect whatever falls through.

Add spring pollen, summer bugs and fall leaf bits, and a track can fill up in a single season. Dirty screens also make clean glass look grey from inside, which is why a window can still look dull right after you wipe it.

What you need.

Nothing fancy. Most homes already have all of it:

  • A vacuum with a soft brush attachment and a crevice tool.
  • A bucket of warm water with a few drops of mild dish soap.
  • A soft brush or sponge, and a few microfibre cloths.
  • A garden hose with a gentle spray, or a second bucket of clean water.
  • An old toothbrush or a small detail brush for track corners.
  • A towel or a clean spot on the lawn or deck to lay screens down.

How to clean a screen.

Only take out screens you can reach safely, usually main-floor windows from inside or from the ground. Note which window each screen came from. They often look the same but do not always fit the same.

  • Lay the screen flat on a towel or clean surface.
  • Vacuum or brush off the loose dust on both sides first. Adding water to a dusty screen just makes mud.
  • Wash with the soapy water and a soft brush or sponge, using light strokes. Fibreglass mesh can stretch or pull loose from the frame if you press hard.
  • Rinse with a gentle spray from the hose or a cloth dipped in clean water. Leftover soap attracts dust.
  • Stand the screen up and let it dry completely before putting it back.

How to clean the tracks.

Open the window or slider all the way so you can reach the whole track. Do the tracks before the sills, so dirt does not fall onto a sill you just cleaned.

  • Vacuum the loose dust, bugs and leaf bits with the crevice tool.
  • Wipe the track with a damp cloth to loosen the stuck-on dirt. Let it sit a minute if it is caked on.
  • Work the corners and drain slots with an old toothbrush.
  • Wipe again with a clean damp cloth, then dry the track with a microfibre cloth.
  • Slide the window or door back and forth a few times to check it moves freely.

Mistakes to avoid.

A screen is cheap to clean and annoying to replace. These are the common ways they get damaged:

  • Pressure washing a screen. The spray can stretch or tear the mesh.
  • Using bleach, ammonia or harsh cleaners, which can damage the mesh and frame.
  • Scrubbing hard or pushing on the middle of the mesh.
  • Putting a screen back while it is still wet, so dust sticks to it right away.
  • Climbing a ladder to pull upper-floor screens. That job is not worth a fall.

How often to do it.

For most homes, twice a year works. Late spring, once the worst of the pollen has settled, is a good time. Fall is the other, after the summer dust and before you close the windows for winter.

If you live near a gravel road, a building site or a lot of pines, the tracks may need a quick vacuum more often. A minute with the crevice tool every few weeks keeps them from packing down.

When to leave it to a crew.

Some screens are hard to reach, stuck in their frames, or on the second floor above a deck or a slope. Some tracks are full of years of packed dirt. Those are good jobs to hand off.

Every residential window clean at Beam’s includes the screens, the tracks and a frame wipe-down, so you do not need to do them first. Exterior cleaning starts at $225 and interior work at $135. If you spot a streak within 48 hours, we come back and fix it for free. Request a free quote online, or call or text 778-583-5057.

Common questions

Can I clean window screens without taking them out?

Yes, for light dust. Vacuum them in place with a soft brush attachment and wipe gently with a damp cloth. For a proper wash, it is easier to take out the screens you can reach safely.

Can I pressure wash my window screens?

It is best not to. A strong spray can stretch or tear the mesh. A gentle hose spray and a soft brush do the job.

Do I need to clean my screens and tracks before Beam’s comes?

No. Screens, tracks and a frame wipe-down are included with every residential window clean.

How often should screens and tracks be cleaned?

Twice a year suits most homes, in late spring and in fall. Homes near dusty roads or lots of trees may need the tracks vacuumed more often.

Ready to plan your clean?

See what the service includes, or request a free quote for your property.

Explore residential window cleaningGet a Free Quote
Call Free Quote
Beam’s
Window Cleaning

Let’s talk about your clean.

Have a question about your windows, gutters or exterior cleaning? Send a text to the crew.

Open Messages

Opens your messaging app. You review and send.